Cisco FMC / FTD eventing

Sometimes there are just too many connections in your network and your FMC cannot handle them. Especially virtual FMC is not very good syslog collector (there is limit of connection in DB). FMC is more suitable as a SIEM – all your security events should still be sent to FMC. Cisco FTD eventing design When you want to log all the connection information there will be lots of syslogs, and

Cisco FTD – permit bpdu frames

In the old days of Cisco ASA transparent firewalls, there was an option to allow BPDU frames in access list. Therefore, bpdu frames were passing through the firewall even some rule later could override it. ASA ACL looked something like this. access-list acl-bpdu ethertype permit bpduaccess-group acl-bpdu in interface inside In the FTD there is no way to allow this using Access control policies. By default, BPDUs are forwarded for

Ping tricks

Change Ping Packet Size Win:     ping –l 1450 IP_ADDRESS Linux:  ping –s 1450 IP_ADDRESS Send 10 packets and stop Win:  ping –n 10 IP_ADDRESS Linux: ping –c 10 IP_ADDRESS Show ping statistics without stopping Linux ping :  Press Ctrl + |  (pipe) hostname:~ $ ping PING ( 56(84) bytes of data. 64 bytes from icmp_seq=0 ttl=117 time=193 ms 64 bytes from icmp_seq=2 ttl=117 time=192 ms 3/3

Cisco SSH access hardening

It is 2019 and plenty of network devices still rely on old crypto algorithms and functions. Therefore, I decided to write down some best practices for hardening SSH on Cisco routers / switches. I tested these setting on IOS-XE 16.x releases.  This article is meant as a write-down of picked security practices. You can find more technical deep-dive meaning of the commands by internet research. In fact, when it comes

Snmpwalk tricks

snmpwalk snmpwalk -v1 -c community … snmpget -v 2c –c community … rnetstat –ix Interface description   Status of Interfaces   System uptime   Interface IP addresses   Last change of interfaces   TCP connection state – who is connected on which port   Other options ifAdminStatus ifOperStatus ifPhysAddress  (mac address) ifSpeed ifType sysContact.0 sysName.0 sysLocation.0

Cisco vs. HP ProCurve VLAN switch ports

Usually, when Cisco oriented networker sets off to the HP networking world, first confusing thing is VLAN port assignment. When speaking about VLAN ports in HP world, the ports can be tagged or untagged (despite the access / trunk ports in Cisco). As you may guess, tagging means 802.1q tagging in Ethernet frames. It is important to realize that Cisco is “port-centric”, whereas Procurve is is “vlan-centric” when speaking about

IPv6 Mobility testing topology

For better understanding and demonstrating of IPv6 mobility mechanisms I designed this simple but sufficient network topology. You can check it on the picture below. I used three routers to describe the mobility process, although one router with three connected networks should be also enough. However, with more routers you can easier monitor and trace the differences between direct and indirect communications with mobile node. There is connected one network switching device

IPv6 Mobility support in operating systems

As with every new standard or technology, also with MIPv6 there is a certain difference between a final RFC specification and real implementation in end devices. The implementation is often incomplete, inefficient or unstable. Therefore, after detailed analysis of MIPv6 specification we designed network topology in our lab environment for testing purposes. We built the topology using Cisco 2800 series routers and set link bandwidths to mirror real-life Internet conditions.